Want to make this lovely wraptite bracelet? Not a problem! Just follow these six easy steps!
Step 1:
Place the gemstone face down on your work surface, place the wraptite loop over the gemstone and press down. It will click into place. We are using faceted garnets as the colour contrast against the silver will look lovely.
Step 2:
Cut two pieces of 1mm wire, or the same thickness as your jump rings, insert the two lengths of wire into the loop holes. Using a pair of round nose pliers squeeze the pliers at the base of the loop on both sides.
Step 3:
Remove the wires and continue steps one and two until you have enough bezels to form a bracelet.
Step 4:
Link all the gemstones together using the jump rings, remember that the jump ring should be opened or closed by twisting and not pulling it apart. Make sure all the jump rings are closed properly.
Step 5:
Using the jump rings add a clasp to the ends. We have used a sterling silver figure of eight clasp with a safety clip and good quality sturdy clasp with an added safety clip for security.
Step 6:
After all the gemstones are linked together and the clasp is attached take the round nose pliers and squeeze all of the loops again to make sure they are tight. Your bracelet is now finished and ready to wear.
Cooksongold