Hi,
I really enjoy piercing, though need to improve at it, but I really like, and would like to be able to do some quite intricate pieces. Have attached a picture (please ignore the design/piece as it was one that went a bit wrong, had to cut it down and solder it on to back piece so not what was intended) but the piercing part itself you can see was as intended, made a couple of errors, the widest part is about 1mm thick and would really like to be able to do finer and more precise work. I have read quite a lot of posts on it on here and have seen the Knew concepts saw mentioned a lot and wondered if it really makes any difference, than just your bog standard budget saw? I have a birthday coming up and my Mum and Dad have very generously offered to buy it for me. Just want to be sure if they are spending all that money that it's really worth it?
Thanks,
Karen
Bookmarks