Hello,
I have made a few rings out of D wire and I need to make some more. Whilst I can make them look OK, I can never get that professional join.
Does anyone have any tips for getting that perfect join in D wire, please?
Thanks!
Bob
Hello,
I have made a few rings out of D wire and I need to make some more. Whilst I can make them look OK, I can never get that professional join.
Does anyone have any tips for getting that perfect join in D wire, please?
Thanks!
Bob
Hi Bob
hold the ring with the two joins togther and then run you sawblade through it this should give you the perfect join, or if they are already soldered run your sawblade through them and resolder.
make sure the joins are flush the sides are in perfectly aligned and solder. Then filing is the important bit, this is because the the ring your filling should be the same thickeness at every angle and the sides are level! Make sure your only taking the solder away.
Remember dont use ten tonnes of solder less is best so you dont take more away then you should while filing!!!
If it's "one of those days" then it ca help to mke wire into a D shape for soldering two straight edges are sometimes easier to line up. The join would be on the straight part.
Then round it on a manderel after pickling
Nic x
Monthly FREE entry giveaways on Blogs!
Shop Blog: http://muranosilver.blogspot.com/
Silver Clay Blog: http://pmctips.blogspot.com/
View images of my work on Flickr: http://www.flickr.com/photos/muranosilver
Bookmarks