Pitted ball

[JewelleryByMandy]

I had a play with this yesterday and love it apart from the little pitts.
Is this something to do with the rapid heating or something? I think i need to invest in a decent torch that i can control

Thanks
Mandy

[Dennis]

Did youn use flux and partially close off the air?

[JewelleryByMandy]

Did youn use flux and partially close off the air?

I used abit of flux but my torch doesnt have a control. Its a cannister with a screw top torch head on it.


Sent from my iPhone using Tapatalk

[Dennis]

I presume that is just a finger ring, so a re-fillable hand held mini torch woul give you more control, as the flame can be changed from roaring to soft.
https://www.etsy.com/uk/listing/5241...SABEgJI1fD_BwE
To make a silver ball, scoop out a shallow depression in a soldering block and melt bits of scrap silver in it using borax or liquid jewellers flux.
To clean it put it in a pickle solution, which can be white vinegar, or a warm solution of alum.

[JewelleryByMandy]

I presume that is just a finger ring, so a re-fillable hand held mini torch woul give you more control, as the flame can be changed from roaring to soft.
https://www.etsy.com/uk/listing/5241...SABEgJI1fD_BwE
To make a silver ball, scoop out a shallow depression in a soldering block and melt bits of scrap silver in it using borax or liquid jewellers flux.
To clean it put it in a pickle solution, which can be white vinegar, or a warm solution of alum.

Sent from my iPhone using Tapatalk

[JewelleryByMandy]

That’s everything that i did. Was just wondering how those little holes appeared.
Thanks


Sent from my iPhone using Tapatalk

[china]

You may have simply used too much heat this can cause (for want of a better word) a boiling effect leaving little holes in the item