Correct flashback arrester

[Roholmes]

Hi can enyone help my find the correct flashback arresters for my oxygen and propane set up as I have brought one but it does not have an high enough pressure for my little smiths torch as the arrester only goes up to 5 bar in propane and need to be able to have a arrester that will go up to at least 10 bars but can not find one at all

[china]

Little torch does not operate anything like 10 bar more like 3-4 Bar

[Roholmes]

Little torch does not operate anything like 10 bar more like 3-4 Bar

The torch instructions say you need 5-9 bars for different tips on the manual for propane

[ps_bond]

I've just read through the instructions from Smiths and can find no reference to 5-9 bar. All I've seen is 13.7 - 48.3kPa (for both O2 & fuel - although there's a later reference to 55.2kPa for the #7 tip) across the range of single & dual tips.
5bar supplying even a Sievert and you'll struggle to get & keep it lit.

http://www.smithequipment.com/files/...63357a_mil.pdf

[Aurarius]

Yes, for tip numbers 2 to 7 the psi range is 2 to 8.
8 psi is significantly less than one bar.

One of the reasons I got the following regulator is that you can see roughly what pressure the fuel is running at:
http://www.rapidwelding.com/dynamic/...x?c=H1384&zl=2

[Roholmes]

[QUOTE=Aurarius;94634]Yes, for tip numbers 2 to 7 the psi range is 2 to 8.
8 psi is significantly less than one bar.

One of the reasons I got the following regulator is that you can see roughly what pressure the fuel is

Thank you I have been looking for one like this for ages but I've already got one but it doesn't have a gauge but when I get some more money I'll defiantly invest in this one already waisted money on one that didn't fit so can't afford to buy another one