Results 1 to 9 of 9

Thread: Making brass balls

  1. #1
    Join Date
    Sep 2016
    Posts
    23

    Default Making brass balls

    Hi im a beginner jeweller and would like some advice on how to make small brass balls. ..i can ball them up on a wire when i flux it but then i have the problem of grinding off the cut section which is impossible with such tiny balls...when i try heating a bit of wire on charcoal block it just goes into a fudgy lump. Ive been using a small butane torch.Any ideas? Thanks

  2. #2
    Join Date
    Sep 2014
    Posts
    2,067

    Default

    You could try drilling small holes into your soldering block with a round burr? Ive done that with silver.

  3. #3
    Join Date
    Sep 2016
    Posts
    23

    Default

    Tried that already but the wire still doesn't melt into a ball

  4. #4
    Join Date
    Dec 2009
    Location
    Central London
    Posts
    8,845

    Default

    Dear Paulat,
    The reason you are having trouble is that for brass your mini torch is not hot enough.

    Make holes in your block as suggested by Sarah. Clean the brass wire with an abrasive, snip into equal pieces, use borax as a flux and a larger torch will easily ball the pieces.

    They can also be tumbled afterwards, with shot and tumbling medium, in a mall plastic box inside a normal tumbler empty of other contents. Dennis.

  5. #5
    Join Date
    Jul 2009
    Location
    Romsey
    Posts
    5,256

    Default

    The zinc content in the brass isn't going to help the situation either.

  6. #6
    Join Date
    Sep 2016
    Posts
    23

    Default

    Very helpful i do have a larger butane torch will try that thanks everyone

    Sent from my SM-G900F using Tapatalk

  7. #7
    Join Date
    Sep 2016
    Posts
    23

    Default

    Still didnt ball up even with a bigger torch:-(

    Sent from my SM-G900F using Tapatalk

  8. #8
    Join Date
    Dec 2009
    Location
    Central London
    Posts
    8,845

    Default

    In response to your question, I balled up a snip of wire in a shallow dip in this piece of charcoal, using a Campingaz hand held torch and plenty of borax.
    The ball measures 1.75mm. perhaps your brass is a high melting variety, or even steel wire, brass coated? Dennis.
    Attached Thumbnails Attached Thumbnails IMG_0999.jpg  

  9. #9
    Join Date
    Sep 2016
    Posts
    23

    Default

    Thanks dennis ive got it to work now with a bigger torch 😊

    Sent from my SM-G900F using Tapatalk

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •