Hi,
has anybody any experience with removing the above...
Regards
Mark
Hi,
has anybody any experience with removing the above...
Regards
Mark
No, but as the data sheet says it's an epoxy resin, it should burn off with a torch.
Use a soft bushy flame and work in subdued light, so that you can see where the flame is being directed. Go on until any carbon residue has burnt off. Dennis.
I have no experience with that type of enamel, but if it is an epoxy resin then you may be able to dissolve it by soaking it in Nitromors paint stripper for a few hours or longer.
James
Thanks Dennis and James for your thought's, i will give both methods a try....
It's horrible stuff....
Mark
I guess because it's a craft product with rather garish colours. The real enamel can be much more gemstone like. Dennis.
Bookmarks