Hi all
I'm new to this forum and have a question
I have done a beginners Jewelry course a couple of years ago , and tried bits and bobs myself since.
On my course I made a 5mm wire silver bangle , which I am attempting to make again
When I made it the tutor did the soldering and I watched .
On my first soldering attempt yesterday I heated the bracelet for a long time with a big blow torch .
The solder wouldn't run for ages and the eventually did but not on the join . Also the bracelet seened to shrink so there was a gap in the join afterwards .
It's quits scary and also very frustrating .
Any advice would be brilliant !!
Thanks
Anna