Advice on repairing a channel setting

[Unhindered]

I'll attach some photos so you can see what I mean, one side is wafer thin and 3 diamonds came out in the sonic (one is placed back in)

I can't figure out the best way to build it up, whether to solder a panel on to the side to be pushed over or solder some strip along the front? Any advice appreciated!

It was only booked in for a rhodium!! I do claws all the time but haven't built up a channel before


Sent from my iPhone using Tapatalk

[ps_bond]

Laser
Guessing most of the wear is on the outside edge, with less in the centre (although the lowest stone in the first pic looks like it'd need much more centrally too).

[josef1]

Yeah Laser

[Unhindered]

I don't have a laser can give it to someone else to do though, thanks!


Sent from my iPhone using Tapatalk