How to invisble /flush set gemstones with video

[johnmoto]

(I HAVE PUT THIS ON AGAIN SO IT IS LINKED WITH VIDEO)
The best way I use is to use an old drill ball 005 flatten of the end make sure the end is polished smooth
And put into Handel ball round , drill hole so the stone fits in so tight it won't come out even if you bang it hard ,
Then with your flat end pusher scim around the edge of the hole about 45 degree angle clock wise or anti keeping a
smooth even pressure until metal is over the stone if done properly you will end up with a bright rim around the stone no
Scratches marks around the stone it will be very clean .
Secondly get another 005 ball drill put it in your drill and with sand paper take the drill down to a fine pin point
And make sure it is highly polished and put that in a grain tool Handel , then with it burnish inside the rim in a circular
Motion until all the metal is on the stone and rim is even .
There you go no mess no buffing over metal getting out scratches dents clean job, believe me it's the best way ben doing this for over 30 years , if you need any help give us a call.
Here is the YouTube link to show you how to video. http://youtu.be/1RVZvnyo2wM
s

diamondsetting4u.com