Hi, sorry I've been quiet, real life is of the not fun and the being busy
I was hoping for some advice, I've made a silver cross from 1.2mm sterling sheet (1 continuous vertical with the two sides soldered on) but the solder lines are quite visible however much I sand... it's a present so it doesn't need to be perfect but I was hoping to salvage it.
I was wondering if I could cover it in PMC slip (like PMC plating) and fire the top, maybe add a design...
Could I have used a little too little solder as it's firmly soldered but it's not raised where it's soldered?
Any other ideas would be great

Thanks
Ceri