Results 1 to 8 of 8

Thread: what thickness sheet do you all use for pendants?

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Apr 2015
    Posts
    63

    Default what thickness sheet do you all use for pendants?

    Having a little wibble and wondering whether to go thicker. I tend to use 1mm as standard,apart from delicate shaped/domed detail but sometimes think it looks a bit thin. Have used 1.5mm before but the bottom often is narrower than the top as my blade appears to go wonky!

  2. #2
    Join Date
    Jul 2009
    Location
    Reading, Berkshire
    Posts
    261

    Default

    I would then maybe go for 1.2mm?

  3. #3
    Join Date
    Sep 2010
    Location
    Banbury
    Posts
    167

    Default

    Hi Silverlining. You've posed an interesting question. I have made pendants out of all different thicknesses of sheet but in the end it's the design that determines the thickness required. With reference to the blade going wonky a possible answer would be to cut oversized and then file back to keep a square edge. I have found if you move the metal rather than the saw when piercing you are less likely to let the saw wander off from vertical especially round corners.
    Didi

  4. #4
    Join Date
    Dec 2009
    Location
    Central London
    Posts
    8,851

    Default

    Depending on your design, one problem can be weight.

    By finishing your edge with an undercut you are hiding the thickness and not getting the best value from your metal.

    File it with a slight bevel so that the top is a tiny fraction narrower than the bottom and it will appear thicker than it is.

    You can also add a frame of wire to much thinner metal and file back to that, to give the illusion of thickness. Filing back should be left until all soldering is completed, particularly of that grade, so that the join does not show. Dennis.
    Last edited by Dennis; 05-06-2015 at 02:31 AM.

  5. #5
    Join Date
    Apr 2010
    Location
    Exeter, Devon
    Posts
    1,803

    Default

    When I was in my class the tutor recommended 0.60mm for putting on the back of cabs and 1.5 if no stones are used. I have a preference for thinner for pendants because it can weigh quite heavy with a cab on and as long as it looks in keeping it will be strong enough. If you have a small pendant it would look stupid if you put it on a 5mm chain, well its the same principal, and as Dennis said its all about the design of pendant.

  6. #6
    Join Date
    Jun 2010
    Location
    Cardiff
    Posts
    988

    Default

    Yup, totally depends on the design and size, is there a specific idea you have in mind? Typically I use between 0.8 and 1.5...

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •