Flux snowstorm

[MJC]

Hi,
Trying to solder some rings at the moment. I'm using a borax cone and dish with distilled water, sterling silver and Sievert torch with a fine tip. After applying heat the flux turns clear. I place the solder onto the join but when I apply further heat the flux expands rapidly and I end up with a huge mass of white fluffiness on the ring which I then have to clean off before trying again. It's puzzling and frustrating so if anyone can suggest where I'm going wrong I would be grateful. Thanks, Michael.

[Goldsmith]

I use a borax cone method, I flux the joint, heat it until the flux bubbles up and then goes clear, then I pick up the solder pallion in tweezers, dip it in the borax, then blow off the excess borax from the solder before sitting it onto the still hot joint, when the fluxed solder heats up the solder pallion sticks in place over the join. Then it's time to gently heat up the whole piece with the torch so that the solder runs through the join.

James

[MJC]

Thanks for passing on your soldering routine, James. I'll give it a try this afternoon. Perhaps I have been over fluxing.

[CJ57]

Or perhaps just heating up too quickly, it is a bit volcanic compared to the liquid fluxes

[LydiaNiz]

I use the same borax/flux method. Agree it may be over fluxing. I usually get a bit of fluffiness, but if you sit it out it settles down almost immediately. As long as it doesn't blow the solder completely out of place I wouldn't worry too much.

[Dennis]

Some of us are too impatient to deal with the flowering of borax, so as Caroline has suggested, we use Auflux/Auroflux instead.

You might decide to join us. Dennis.

[LydiaNiz]

Dennis, I've got my auflux in a spray bottle now as suggested. I do use it more as a result. But still sometimes forget. Old habits!

[Dennis]

Ha Ha, well Ive known people to use anhydrous borax in alcohol to avoid that bubbling, but you might set your hair alight.

[MJC]

Thank you all for your help. Yes, Caroline, volcanic is the word I left out of my description. The flux often carried away the solder and left it high and dry. I've tried the method suggested by James (with less flux and gentle heating) and it is a lot better. I'll add Auflux to my next order and experiment with it.

Michael

[Dennis]

I'll add Auflux to my next order and experiment with it.Michael

Well then as Lydia mentioned, you can transfer a washed pump from an empty soap dispenser to the Auflux bottle. They usually fit and make it easier to use.