Help with soldering a bangle 7mm x 2.5mm

[Aurarius]

Yes, my apologies to both Dennis and Caroline. I was unfortunate in my timing.
I'm not always good at timing, though I'm usually good at being unfortunate.

[CJ57]

we are all in such a hurry to help we sometimes tend to talk over each other and the posts come in together. At least we were in agreement for a change

[Patstone]

I have the torch Dennis mentioned which I keep for larger jobs. I was asked to make a 2mm cuff over an inch wide, had to solder gold squares on and it coped with that perfectly, its a bit scary to use until you get used to it, but it will tackle most things. Mine is the GoSystem one but with a large cartridge on.