Hi
I'm ready to throw my barrel out! I'm struggling to get a glossy finish. I used the shot the barrel came with and got a good finish,but it left a shadow around raised bits, so after reading all the treads I could find on here re shot etc I got some smaller shot from MM. This gave a satin finish, like lots of little pin pricks, so I removed all the long sharp bits, but it made no difference. Then following a recommendation on here I ordered some shot from Rio grande, I'm still getting the same problem....what am I doing wrong? I'm using a teaspoon of barrelbrite and about 1/3 full of water, any suggestions?
Thanks
Lorry