-
Bending a sharp corner in metals
Andy asked about bending some silver into a sharp corner to fit a lute, I am not sure I can visualise what the job is, but in the trade when we make boxes that require sharp 90 degree corners we always score the inside of the bend. This can be done with a graver, a file or what we call scorers, these are a cutting tool that can score a groove when pulled along a deep scribed line in metal. Once you have scored a line the metal will bend easier at this point and create a sharp corner. The score line does not have to be deep, although when bending thick metals a decent depth of score line will be needed, but for Andy's 0.75mm. fine silver a slight line will do. But I would advise experimenting with some same thickness copper sheet before doing it on the silver.
Here are some photos of one of my scorers, I have a few, each with a different cutting angle as different angles are needed when scoring for multi sided shapes, I made some of my scorers by bending and grinding the tangs on old files, this is one of them.
James
-
I used a scorer for bending the 1mm. thick 18ct. gold on the corners when making some of these cigarette lighters, way back when smoking wasn't frowned upon.
James
-
damn, those are beautiful! it would actually be worth taking up smoking just to use them.
-
Yeah, but you'd have to sell the gold to afford it...
-
I am trying to work out a scorer to order from Cookson but unsure which one (or two). I would use it for scoring smaller projects probably using metal that is not too thick. I also need a tool for engraving small details, I have a Dremel pendant style drill with a multitude of bits but I'd rather do it by hand. There are just too many to choose from so I don't know what would be best to start with!
-
Hi Sandra, a scorer works by pulling it along rather than pushing, so it is not the same as as a graver, or scorper. As you can see from James' posts above, you can make your own by bending (while red hot) and grinding the tang of a file. I doubt there is anywhere to buy one.
If you feel that you are not upto this at the moment, then short lines, upto about 2cm can be scored by starting with a tightly strung saw until you are about half way through at each end. The cut will be rather shallow in the middle, due to the blade sagging, but the top end of the blade stays fairly firm, so use that.
Then continue with a medium cut triangular needle file and finally with a medium cut square needle file, until you just see an even line appear on the other side. This will give you the means of creating a right angle and checking it on a metal block, or set square.
Once you are satisfied with the angle, you must run some solder in to maintain it. Please note that if measuring on the inside, each side will become shorter when folded. So with a box made of 1mm thick metal measuring 10x10mm on the outside, the walls will be about 8mm long on the inside, depending on how deeply you have scored. Dennis.
Last edited by Dennis; 11-04-2014 at 04:02 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks