Counter sunk gem setting.

[Sassoon]

Hope someone can help, I'm really struggling to set a 3mm gemstone into a sliver ring,once the seat is cut I can't seem to smoothed it over to create a secure fit iv tried using a burnisher rubbing around the edge but with no success. Thanks john.

[ps_bond]

Is the metal annealed?
What is the stone (or more precisely, how soft is it)?

[Wallace]

Hi John,

did you mean flush setting?
can you show a picture of where you are at the moment?

[Dennis]

When I was taught flush setting the class also spent time on making a much heavier setting tool than the burnisher normally suggested. Over the years as my hands have become more feeble, I have been very glad to have it.

I also noted recently, that Anastasia Young in her setting book recommends something similar. It is very good at not making a mess of the surrounding metal.

Dennis.

[Patstone]

Dennis, I love that ring, how did you make it so that the shank and the bezel are all in one. Was it cut from one piece of sheet, would you mind if I made one similar to it, not to sell, but for myself. I wont make it exactly the same, and I will only make one. It will test my skills too, always reach for something you cant have, if nothing else it stretches you a bit. Lol. I have a screwdriver that I made into a bezel pusher too, but mine is a bit smaller.

[Dennis]

Hi Pat, The ring was made on a short course years back, 'Making a hollow ring' from sheet metal. It is rather demanding, even with instructions, as the pattern has to be designed to fit the stone at the outset. Once the ring is made, a large jump ring is soldered in to bear the stone. Otherwise it would fall right through.

Everyone on the course made it, so feel free to use the idea. I shall look up the instructions and post them here tonight. Regards, Dennis.

[Patstone]

Thanks Dennis, next thing is, am I skilled enough to make one.