-
Bead setting
Finally had some time to spend on practice rather than deliverable setting, so I went back to doing some small stuff:
Not clean enough yet for customer use, but not bad. Stone at the rear ended up wonky.
1mm CZs set along the side of a 1.1mm square wire. Once I've done a few more I'll look at setting into the adjacent side too, that should be a laugh.
Still keen to go and get some training in this in Holland early next year...
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks