Not sure if I am in the right section as I am asking about something a bit off of mainstream. I am looking into electroforming copper onto glass and ceramic beads and the like and am trying to get a kit together for experimentaion and small production if I can get good results. I know little about electrics and want a foolproof bit of kit to deliver the power. Some of the tutorials I have found say 3Amp is the maximum requirement for small item electroforming but I have found this http://www.circuitspecialists.eu/adj...02x-p-169.html which is only 2Amp. Can anyone tell me if this will be adequate for what I want. It does have the required foolproof controls! and is within my budget! Any advice by anyone who knows about the subject would be much appreciated.
Al.