Ah... I'd forgotten about the Eggs. I was still puzzling over the golden gun, as that would seem to be a bit of a waste of your skills, but couldn't remember anything more ornate.
Ah... I'd forgotten about the Eggs. I was still puzzling over the golden gun, as that would seem to be a bit of a waste of your skills, but couldn't remember anything more ornate.
sorry to bring up an old post everyone, a quick question would an arbor press be sufficient to use the bonny doon sillouette dies to cut silver sheet pieces out and the texture plates? or would i need a hydraulic press? Can anyone recommend a good press if so?
regards
Stuart
Made in Wales.
www.scsilver.co.uk
www.scsilver.blogspot.com
http://www.facebook.com/group.php?gi...5799906&ref=ts
Cymru am byth!
Well I've seen some pretty big arbor presses and you can buy some pretty thin sheet silver... but if you're talking about using a little 1T press on 1mm silver for shapes bigger than a tuppence then no, it won't.
There are lots of hydraulic presses cheaper than a Bonny Doon and of course the fly-press of the thread title.
Made in Wales.
www.scsilver.co.uk
www.scsilver.blogspot.com
http://www.facebook.com/group.php?gi...5799906&ref=ts
Cymru am byth!
Potter's have quite a big selection http://www.potterusa.com/index.php?o...d=12&Itemid=53
I have one of these but I don't use it for cutting.
Joe
Bookmarks