Hi

I suppose this is and extension to the cleaning rusty tools thread. I just wondered if anyone had any idea how I should clean a second hand rolling mill, which I bought recently.
It's not very rusty as such, just a bit tarnished mainly, although some areas are beginning to rust, if that makes sense! Can anyone suggest anything?
I did think about cleaning it with Brasso or liquid silver cleaner!

And I have also bought a Microweld too (from the same person), it has been serviced about 4 years ago and used very little after. The seller insists it's fine to use as is, but I understand it's better to use a Microweld often as they don't like to be stood unused? It starts up OK, but is it dangerous if not serviced often?

Many Thanks

Jilly Seweller