Results 1 to 6 of 6

Thread: Advice please on coiling half hard wire

  1. #1
    Join Date
    Jan 2010
    Location
    Cheshire
    Posts
    46

    Default Advice please on coiling half hard wire

    I have ordered some half hard wire for my next chain maille project but I'd just like a bit of advice about making the jump rings with it.

    On my last attempt of using half hard wire the rings seemed to come out in the variety of sizes.

    Is this normal or is there anything that can be done to stop this happening?

    Thank you

  2. #2
    Join Date
    Jul 2009
    Location
    cotswolds
    Posts
    3,383

    Default

    How are you coiling? You really need to use a handdrill or electric screwdriver with a snap in three prong chuck if you want to get consistent coil sizes. If you wind by hand it's almost impossible to maintain constant tension.

  3. #3
    Join Date
    Aug 2009
    Posts
    1,451

    Default

    yeah what G says and hold the wire taught as you feed

  4. #4
    Join Date
    Jan 2010
    Location
    Cheshire
    Posts
    46

    Default

    Yeah, that's exactly what I did but maybe I wasn't holding the wire a taught as poss. But I know half hard will spring back but does in spring back more or less even on all the rings and is there a good length of coil to have?

    Thank you.

  5. #5
    Join Date
    Jul 2009
    Location
    cotswolds
    Posts
    3,383

    Default

    I tend to coil between 3 and 6 inch lengths, depending on how I'm going to cut them. Feed the wire through the thumb and forefinger of your non-dominant hand to maintain tension. If you coil tightly to the mandrel, the springback should be consistant throughout the coil when you release it.

  6. #6
    Join Date
    Jan 2010
    Location
    Cheshire
    Posts
    46

    Default

    Right thank you, I'll give it a go tomorrow...........but first I need to figure out what hand is less dominant lol (left handed.....most of the time!!!)

Similar Threads

  1. advice please using metal clay and silver wire
    By lorraine in forum Need Help? Ask the Experts!
    Replies: 0
    Last Post: 27-03-2010, 11:48 AM
  2. Silver wire - soft or hard???
    By Milomade in forum Maille and Wirework
    Replies: 23
    Last Post: 26-02-2010, 03:09 PM
  3. Designed something for my half drilled pearls...
    By Mila Jewellery in forum Show & Tell!
    Replies: 25
    Last Post: 03-01-2010, 12:49 AM
  4. Advice on silver wire sizes
    By AliMac in forum Maille and Wirework
    Replies: 4
    Last Post: 01-12-2009, 10:28 AM
  5. Hard Sterling Wire ?
    By Fiona in forum Need Help? Ask the Experts!
    Replies: 4
    Last Post: 21-08-2009, 09:50 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •