I'm interested in making a version of this setting with these interesting prongs but how do you get the stone in? Are the prongs bent backwards slightly or to the side?
That's a fabulous ring Dennis. Just the sort of thing I love! The picture is from John Cogswells Creative stone setting book. He offers it as an example of the sort of thing you can do with a bezel but doesn't tell you how to achieve it.
Mmm long prongs, that helps give me an idea of how it might be achieved.
I want to do a round set bezel with 4 prongs in an x formation. I need to draw a wee picture to show you how I think it could be done then you can tell me if I'm barking up the wrong tree
If you make your notch too shallow, the claw will move sideways instead of closing. You might have to cut in further with a narrower V at least past the half way mark, to weaken the metal enough. Try it with a strip of copper in your hand first.
You will also need the outer edges to diverge, if you want them to end upright, and possibly another five mm longer to make them easy to set. Pliers aren't good for closing strips. Fingers, or a push against your bench, or a vice on two opposing claws would be better.
Then cut them to the desired length, have the tops level and matching, and the outer edges upright.
I like fancy shanks, so I solder bevelled square wires together in the flat to make a strip. When bending, keep the messy soldered side inside the ring, where it will be easy to polish. Dennis.
That gives me alot to think about. I shall be printing it out Dennis so that I can follow it properly. A bit more complicated than it looks but on the day that I want a challenge this is what I'll be doing
Bookmarks