Results 1 to 3 of 3

Thread: Brass brushes

  1. #1
    Join Date
    Feb 2016
    Location
    East Anglian
    Posts
    324

    Default Brass brushes

    Good morning....that’s the time I am writing this anyhow (U.K.)! Just a little bit of advice please. Circular brass brushes....where do you get yours from? I bought a couple of dozen from eBay and even keeping the revs down they tend to disintegrate after a very short time spraying the “bristles” into my shirt etc and causing much irritation. Essential to wear eye protection.


    Sent from my iPad using Tapatalk

  2. #2
    Join Date
    Dec 2009
    Location
    Central London
    Posts
    8,248

    Default

    Yes, they need to be run at low speed and have a water or soap drip tube. Ideally you construct your own device for this, using a box and a low voltage motor.

    Walsh have a choice of brushes, but they might not be better. https://www.hswalsh.com/search-produ...ms_per_page=24 Dennis.

  3. #3
    Join Date
    Feb 2016
    Location
    East Anglian
    Posts
    324

    Default

    Thanks Dennis. I will give them a try.


    Sent from my iPad using Tapatalk

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •