So, I could cast in resin and think that is what many would advise but surely there is a way to do this?

I did my original research and bought Lillyglaze and Microglaze as being very good products out of the many choices available... Microglaze to seal my image, Lillyglaze to seal the metal mount interior and affix the glass cabochon with no yellowing.

..then I find out water dissolves Lillyglaze. Fool that I am, I had assumed this was all waterproof!

So my question is to all experienced persons - are there products I can use to do the same process - print image, seal image, cover image within metal mount with glass and affix glass - that give a waterproof end result?

Very, VERY grateful for information and advice on this!

Happy Yule to all!