Results 1 to 2 of 2

Thread: Bending wire

  1. #1
    Join Date
    Feb 2016
    Location
    East Anglian
    Posts
    308

    Default Bending wire

    After posting for advice concerning bending 3.5mm square section silver I had as usual a number of suggestions. Thank you all. Dennis suggested getting hold of a simple and relatively low cost tool. Ring shank bending pliers TP191 from Walshes of Hatton Garden. He did feel that 3.5mm might be on the upper limit of this tool, so I looked further and found its big brother in the same shop but costing over twice as much. I mulled this all over and descended to take the cheaper option as it wasn’t a fortune. 2 days later it arrived in the post. I am delighted to say it works a treat. Easy to use and above all took away all the sweat and pain of hammering on a mandrel, only a few taps needed to perfect the circle. I unfortunately have damaged and arthritic hands and this tool has been a “life” saver.
    Once again shows the value of our forum.
    Ring Shank Bending Plier - TP191 For £30 odd including postage! The beauty of it is that being like a largish pair of pliers it stores in a rack on the workbench and takes up no valuable space.

  2. #2
    Join Date
    Dec 2014
    Location
    South Australia
    Posts
    1,433

    Default

    Great to hear you found a suitable solution, that is one of the things that makes this forum "different" everyone is willing to share their knowledge

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •