Results 1 to 3 of 3

Thread: Help! Solder join showing

  1. #1
    Join Date
    Feb 2020
    Posts
    7

    Default Help! Solder join showing

    Hi! I made a ring that needs to be handed over tomorrow and I was really happy with it then just saw in a certain light I can see the solder join faintly! How could I get rid of it? Do I need to start again>?
    Attached Thumbnails Attached Thumbnails IMG_2201.jpg  

  2. #2
    Join Date
    Dec 2009
    Location
    Central London
    Posts
    7,983

    Default

    Unfortunately solders dont always match, particularly if you are using medium or easy, but not so much with hard.

    The only remedy is to have a very close fitting joint. Hopefully your customer will be forgiving, or accept it in the interim, while you make a new one.

    Welcome to the forum, Dennis.

  3. #3
    Join Date
    Jul 2009
    Location
    West Midlands
    Posts
    1,407

    Default

    I'd suggest you get yourself one of these https://www.theloupestore.co.uk/Tech...ifier-327.html which will enable you to see where you need to make any improvements to your finishing etc, if any.
    Jules

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •