Results 1 to 10 of 15

Thread: Leaf and rain drops

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Aug 2019
    Location
    Oxfordshire
    Posts
    231

    Default Leaf and rain drops

    This is the brooch that I've had some trouble setting the round CZ, due to my inexperience with flush setting.

    It is sterling silver and transparent champleve enamel which has been engraved to 2 levels so that I could get some ribs on the leaf. The rough cutting down to the 2 levels was engraved using a home made pneumatic assist system, the fine lines were hand push engraved. I wanted to see if I could get a 3 dimensional look on a flat piece of silver. The pear CZ is bezel set with hammer and punch. The overall length is around 62mm. I think the enamel blending could have been better, if I had used a bit more water to facilitate the mixing of the colours the graduation between the colours would have been better. After applying the enamel it was ground down flat with a carborundum stone and refired to regain the glaze.
    Attached Thumbnails Attached Thumbnails EO9A1543.jpg  

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •