-
Separate tools / equipment for working with 925 silver and with copper
Hi folks, very newbie question here.
I will be working with both silver & copper as I like both.
I know not to put copper (or steel tools) into the silver pickle, and I think I was told not to put copper peices into the same barrel as silver pieces ... ie use a 2nd barrel, but does this need to avoid contamination be taken further ?
So, can you use saw blades & files on both, or are 2 sets needed? Even though files are periodically cleaned off, surely some metal would transfer? Or would it be too little to worry about?
Many thanks, Hal
-
No Sterling is alloyed with copper. Copper and silver can be worked with the same tools and in the same pickle. Some members even barrel them together. That goes for brass too.
Iron is a bit more tricky, because quite small traces in your pickle pot can turn silver pink due to deposition of copper which gradually builds up as copper sulphate in the solution. Dennis.
-
Hello Dennis, that's great news, thanks.
I should've explained better re silver and copper :
I use copper blanks as backing for repousse pewterwork - now that I can (just about) saw copper ... I'm not limited to commercially available shapes / sizes
Working with silver is very new.
Thank you, Hal
-
Mm well, pewter is defiantly a No No anywhere near silver. Dennis.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks