Here here Dennis. Its the bane of my life, you go to a craft show and other stallholders say its "handmade" what they mean is they bought the components and glued them together.
Here here Dennis. Its the bane of my life, you go to a craft show and other stallholders say its "handmade" what they mean is they bought the components and glued them together.
What if you cut off abit of tube the correct height & solder it to a flat base..what's it called then?
Bezel, collet?
It's just a rubover setting either way & as Dennis said, you need a ledge or base for the flat bit to sit on ( by whatever means ).
And having been made to make a lot of tube when I was training I can assure you it has a seam because it starts off as sheet. It still as Chris says has to be soldered to the piece having sawn a bit off so in my eyes still handmade because you have the skills to use a saw, solder and set a stone
My message came over a bit hoity toity didn't it. Put it down to having gone away for the weekend and come back with a bad cough, so sleepless nights for both. It's just that one chap in the regular craft show we go to, states all jewellery handmade. Can you call it handmade if its components bought in and superglued together. Whereas ours really is handmade, apart from very fine chain, we make everything sometimes even the tubes and it takes hours sometimes. I tend to buy tube now because its quicker and cookies finish is better than mine.
I think of bezels as having thinner walls and being made to fit the individual stone. Ohhh the handmade also thing boils my blood.
What I do is once you have cut your ledge or you if you have a collet inside for stone to sit on what is the best way then use a ball stick graver its curved edge is ideal for the curvature of the stone once adjusted burnish inside edge then push walls tight onto stone so there is no gaps , if you find this to difficult then just give it to one of us stone setters.
Web. diamondsetting4u.com
Instagram. diamondsetting4u
To get the ledge in the first place, use a ball burr to get the stone to fit, then use an inverted cone/cylinder (whatever they are) that can cut flat & follow the bottom of where the ball burr went...probably what I'd do at least.
Bookmarks