Hi can any one direct me or knows of a site which sells 3.5mm-4mm thick 18ct gold sheet. It seems most sites only sell up to 3mm, I don't want to cast as this will cost me more in waste whilst shaping.
Thank u
Hi can any one direct me or knows of a site which sells 3.5mm-4mm thick 18ct gold sheet. It seems most sites only sell up to 3mm, I don't want to cast as this will cost me more in waste whilst shaping.
Thank u
Hi Tom,
Welcome.
Have you tried Bairds? (Goldline.co.uk)
My Facebook page. http://www.sleepingdragon.co.uk
Thanks for ur reply
just looked and can't seem to find what I'm after....
I'm looking for a peice of 18ct sheet 15mm high 8mm wide and 3.5-4mm thickness so I can shape into an ingot like this one I made out of silver.
I am sure if you gave Cooksons, Goldline or Betts metals a call, you could get a better solution. Sometimes a call to clarify is better than an onscreen programme.
My Facebook page. http://www.sleepingdragon.co.uk
Called cooksons with no luck as it would cost to much for a small piece. May have to settle for 3mm thickness. Will call the others. Thank u
I'm new to this game so will investergate "swear soldering" is this difficult??
Cheers Dennis
I had considered 6mm square wire, I have a Durston mini rolling mill which I will use, so the next question is....... Will a 6mm square by 11mm long roll down to 4mm thick 6mm wide and roughly 15mm long??? Any tips on doing this??
Thanks
Last edited by Tom; 26-05-2015 at 02:11 PM.
Bookmarks