Originally Posted by
ps_bond
You're familiar with the phrase "no good deed goes unpunished"? Is this the one where your supplier "accidentally" sent you a CZ?
It's always a risk with custom work that someone changes their mind, unfortunately - at least you've got evidence that they were happy with it when they saw it.
My temptation would be to say that the beading cannot work with the existing setting and that the design works around that accordingly. Not sure what the setting is, admittedly.
If you were set on adding more beading - assuming it's the silver part - I'd pull the stone, cut the existing beading off & make up 2 new full rings in beaded wire to replace it. Solder them back on with easy, reset the stone. However, that's a moderate chunk of work for something where your profit margins are already low.
(Equally, per belette's comment it might be possible to laser on additional bits, but it wouldn't be fun)
Bookmarks