Foredom Micromotor hammer action handpiece

[Dennis]

Just unscrew the grub screw and reverse the point so that the flat end shows. Then you can just smooth the edges and leave it at that, or give it a flatter shape, like a bezel pusher.
It is quite fierce , so will need the lowest speed and not much pressure.

Caroline, the pliers are the gentlest of all setting tools for tubing. You just tickle the edges of the setting, without any stress to, say thin wires they might be soldered to. Dennis

[Susie]

Thanks so much Dennis. Will give it a go.

[CJ57]

Hi Dennis
I know this original post was a while ago, but i was wondering if you could advise on what tip i should use to set stones using the dremel engraver?
I want to set some large stones using thick bezels, and have now bought the dremel engraver. What kind of shape should i be using the hammer down the sides?
Thanks
Susie

I wish I'd know Dennis was right about the noise and it went straight into the cupboard:/