-
Flush Setting Tiny Diamond
Hi all,
I've taken on a job that's got me wondering.
I am needing to flush set a tiny tiny diamond (<1mm) into a 9 carat gold band. I know this can be done because I took the diamond out of his grandfathers ring to set into a new one I'm making re-using the gold and stone.
My main concern is measuring and holding the stone (it's so small that if I drop it then it'll be gone forever!) and again because of the size of it I am finding it near impossible to measure it with a caliper. Is there a tool to assist with this? I am thinking a small blob of grease on the end of a pin may be best to hold it (which would in turn make it easier to measure)?
My other concern is using a burnisher on such a small hole to fold the gold over the diamond to secure it in place. I am thinking of grinding down a pick and polishing to make my own however if anyone can recommend a tool that will make the job a lot easier than I'd welcome the suggestion!
Thanks in advance,
Sam
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks