-
Stone setting - wax carving
Hello All! I've started to carve rings out of wax, but I'm unsure when it's cast how I set the stone. Do I have to make sure that the wall of the stone setting is thin enough to be able to push it in? Or is it a case of glue-ing it in? My style is similar to the attached picture, and it doesn't look as the the stone has been set in the silver, rather it's been glued in? Any ideas, as if the wall is as thick as the picture I can't see how it will be able to be pushed in over and around the stone? Thanks as always!
Daisy
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks