Hello all,

I've been asked to mend my father in law's wedding band that he had to have cut off his finger after he broke it. Ouch! It was a clean cut I believe (haven't seen it yet) so I assume the edges should match no problem.

I have jewellery experience, predominantly silver, but I'm very rusty after taking a break for the last year. So I'd like to do the job, but I'm very nervous about getting this wrong. The last thing I want is to melt his wedding ring!

Could I trouble y'all for any advice you can offer, however basic, for doing this straightforward (for most) job? I'm hoping my small handheld blowtorch will be sufficient, as that's all I have access to these days. Should gold be treated much differently than silver? Any special techniques I should bear in mind?

Any advice appreciated. Treat me like a complete beginner.

Thanks lots!