hi everyone,

this is a bit of a beginners questions, previously i have always used the silver bezel wire cooksons sell & for the smaller stones i find it is to high so i am going to make some of my own. Is there anyone with some advice on the best way to do this? im setting alot of 10mm round cabs and 10*8mm oval cabs i was thinking 2mm high? i would most likely make this out of sterling would i be better using fine silver if so should i buy thin wire and roll it out?

sorry seems a little basic but its something iv not got round too doing yet. iv been casting for a year yet iv not even done some simple stuff talk about doing things in an odd order.

thanks

Stuart