Originally Posted by
ps_bond
On holding, if you have a suitable grain tool that the table just fits inside, dampen the tool with just enough water so the surface tension holds the stone. If you don't have a suitable grain tool, make one up from an old burr (grind the end flush, drill into the end a little way & form the cavity with a ball burr then grind down the outside to make it less bulky).
Similarly, for the burnisher, make one from an old burr... Snap off the burr head, use a rotary tool of some sort & a suitable abrasive to grind it to a fine ogive & polish.
Bookmarks