-
Hand engraving a shape in silver?
Hi, a customer wants a certain symbol on her silver cuff bracelet. It is a square inside a circle, the square is on its end like a diamond.
Usually I stamp shapes in to the bracelets I make but can't get a stamp like this.
Any suggestions??
-
Hi,
I would think etching would perhaps be the most simple answer to this, unless you're a dab hand at engraving, which I think is a skill that takes quite some time to master - but wiser folk than me will appear shortly with their answers.
Good luck
Sue
-
Etching would work and be relatively quick and easy to do, of if not how about getting someone to laser the symbol on?
Jules
-
If it's not too small, it would also be simple to pierce with a saw and layer on, or use as it is.
Alternatively you could make a wire ring, or use a jump ring and insert the square. If small the square could be a slice of square wire or tube. Dennis.
Last edited by Dennis; 24-02-2016 at 09:48 AM.
-
I'd be going with Dennis on this, but only because I have yet to etch a piece which didn't have some artefacts on it.
-
Or... if you're not after super-crisp edges, you could carve the symbol into a wax and cast it for a more organic look.
Nick
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks