Search:

Type: Posts; User: pcoz; Keyword(s):

Search: Search took 0.03 seconds.

  1. Replies
    8
    Views
    2,439

    Will give that a go, thanks.

    Will give that a go, thanks.
  2. Replies
    8
    Views
    2,439

    There seem to be two problems, getting the larger...

    There seem to be two problems, getting the larger copper piece to the same temperature as the smaller brass piece, and a layer of oxide forming on the copper.
  3. Replies
    8
    Views
    2,439

    I am soldering a small brass piece to a larger...

    I am soldering a small brass piece to a larger copper piece, so the brass gets hotter than the copper (since the rest of the copper acts as a heat sink, because copper is a good conductor). I...
  4. Replies
    8
    Views
    2,439

    Soldering brass to copper

    I am being spectacularly unsuccessful trying to solder brass to copper. The issue seems to be that the copper oxidises very quickly (using borax flux) so the solder flows onto the brass but not the...
  5. Replies
    12
    Views
    7,241

    Very nice, why the gum leaf?

    Very nice, why the gum leaf?
  6. Replies
    3
    Views
    1,409

    Maybe try very lightly sanding (e.g. 1200 or...

    Maybe try very lightly sanding (e.g. 1200 or higher grit) the anodised aluminium sheet before sublimation printing.
  7. Replies
    11
    Views
    6,016

    "Commercially available with lugs," I think you...

    "Commercially available with lugs," I think you can get from DIY castings dot com.
  8. Replies
    7
    Views
    13,497

    Manchester Minerals, search for Facet Rough...

    Manchester Minerals, search for Facet Rough Emerald.
Results 1 to 8 of 8