Search:

Thank you very much Dennis, I will start like that. I wasn't sure if there was a rule of thumb, say, always make 1 size smaller for example if you are going to texture it.
Many Thanks,Kat

Hi,
I'm getting back into silversmithing after an 8/9 year break. I would like to start with a simple hammered bangle or ring, and I have the method jotted down to work out the wire length I need,...

Well i mucked up the stamping...tiredness from a newborn getting to me..ha ha!! So i will attempt again,but just a simple open cuff (but obv not a thick one,just a narrow 5mm but can open /close!...

Thank you very much all of you. Yes i see a bit a clearer in that photo Anna,think i understand how you mean...im going to give it a go...

Thankyou, Kat

If i used 5mm wide do you think 0.84mm is too thin?
Kat

Ahhh iv just replied and its vanished...grrr!

Thanks for the replies. Ideally i would of loved to have made one like Anna suggested, but i just dont understand how to do it. I understand soldering...

Hello,

I have been out of the loop for a long time growing a little person, she is 2 months old and i would like to make her a baby bangle/bracelet for her 1st christmas. Now i dont have any idea...

Well i found a metal one(round) on the internet for £29,so iv ordered it as i think its the right size,but as it seems cheap compared to others il have to wait and see!! Thanks all

Thanks Dennis and Carole,
Yea i was thinking a metal one would be much better,but think a bit out of my budget at mo,i have seen one that seems quite cheap compared but im thinking it must be a...

Hello all,
This is my first proper post,so i apologise if it seems an obvious/silly question!
Im looking to get a bangle mandrel and getting very confused by the different sizes that are on offer...

I love them all too,especially the last two,the matching pendant and cuff! Have you etched the design,its lovely?