Yes, but you will need more heat.
As you increase your wire size, you will eventually have to decide on a bigger torch, unless you have bigger tips already. Dennis.
Printable View
Yes, but you will need more heat.
As you increase your wire size, you will eventually have to decide on a bigger torch, unless you have bigger tips already. Dennis.
I find the best way to get a super clean join after sawing is by using a flat sided needle file in the join, pushing both edges towards the file and gently drawing the file back and forth. Good luck!
Dennis has a point, I have made a few bangles and am using a Dremel torch - 3mm round seems to be very difficult to heat. (Possibly ok for dome one with experience!) I can't buy any more tools till Christmas so I'm focusing on small things at the moment.