-
5 Attachment(s)
Making a pendant...
After everything I learned on here I thought I will add something to the forum. It is an overview of the process I use to create a pendant where I took a bit of time out to snap pictures with my phone.
Shape pierced from sheet, tumbled and given reasonable finish
Attachment 9629
Bezel plate and bottom plate marked out.
Attachment 9630
Bottom plate drilled.
Attachment 9631
Bezel and bottom plates punched out.
Attachment 9632
Wire for posts (and temp handle) with attachment jumpring.
Attachment 9633
-
5 Attachment(s)
Making a pendant part 2...
Preparing to polish difficult to reach side of bottom.
Attachment 9634
Bottom plate fitted and bezel strip cut.
Attachment 9635
Bezel soldered closed.
Attachment 9636
Bezel 'rounded' and sized.
Attachment 9637
Bezel soldered to plate.
Attachment 9638
-
5 Attachment(s)
Making a pendant part 3...
Bezel pierced.
Attachment 9639
Posts soldered to bezel.
Attachment 9640
Spacer fitted to position bottom plate.
Attachment 9641
Bottom plate soldered.
Attachment 9642
Ready for assembly.
Attachment 9643
-
3 Attachment(s)
Making a pendant part 4
Attachment ring wedged in position.
Attachment 9644
Everything soldered together.
Attachment 9645
All done with stone fitted.
Attachment 9646
Frans
-
Thanks for that Frans. Very interesting.
-
Thank you Frans - it's really helpful to see the different stages (and in what order) a piece goes through - I can imagine when you're wrapped up in making something, it must break the flow to stop and take a photo - but it is much appreciated.
Sally
-
Nice to see the process great pictures
-
Thank you angmc, Sally and Josef1. The process is what interests me but I am no photographer as I shake too much and battle with the focus.