View Full Version : Getting into those nooks and crannys!
JewelleryByMandy
14-02-2018, 11:26 PM
So, ive had a go at this pendant. Just ideas ive nicked for practice. Thing is, i cant get into the crevices of the petals where the flower centre is. Dennis, i got the polish wheel thingys in different colours and theyre fab! They just dont get right in there!!! Any tips anyone? Ta... 😁
Dennis
15-02-2018, 12:54 AM
A difficulty for everyone, not just you, Mandy. One way is to use the tip of a burnisher first, in anticipation and then the polish wheely things.
Eventually you can get a tumbler with mixed shot, but even they don't reach all the crevices. Dennis.
enigma
15-02-2018, 10:54 AM
I use the Everflex rubber burrs and steel wheels and sometimes a very fine diamond burr if needed too.
I use bristle brushes to get into the difficult bits
JewelleryByMandy
15-02-2018, 12:06 PM
Thankyou all x
Sent from my iPhone using Tapatalk
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.