View Full Version : What guage metal for small silver hearts
paulat
22-03-2017, 03:11 PM
Hi id like to cut out small silver hearts to solder on a copper disc but ive never cut anything this small...wondering what the best guage of sheet to use to make it as easy as possible? Thanks
ihttps://uploads.tapatalk-cdn.com/20170322/063b75c5733ee67064f11d2cca16f14e.jpg
Sent from my SM-G900F using Tapatalk
Dennis
22-03-2017, 05:04 PM
The gauge of sheet is not that important Paul. It just depends how much you want it stand up. From your drawing, I would suggest 0.8mm sheet.
To cut them out, start with a strip a tiny bit wider and use a 3/0 saw blade. Do not cut the notch in the top first time around, but hold the partially cut charm in a small hand vice and do it with two cuts later.
This is the sort of thing and it can be made safe against scratching with masking tape. http://www.ebay.co.uk/itm/RDGTOOLS-JEWELLERS-SMALL-HAND-VICE-SMOOTH-JAWS-WATCH-MAKING-JEWELLERY-TOOLS-/291493772038
There is tons more to say, for instance to make a stencil for the hearts, so shout out if stuck. Dennis.
paulat
22-03-2017, 05:09 PM
Great Dennis will have to get one of those...only got 0.5mm fine silver sheet at the moment. ..will have to order some 0.8mm... thanks
Sent from my SM-G900F using Tapatalk
metalsmith
22-03-2017, 08:24 PM
Great Dennis will have to get one of those...only got 0.5mm fine silver sheet at the moment. ..will have to order some 0.8mm... thanks
Sent from my SM-G900F using Tapatalk
Give it a go in .5 and see how you find it. You have it to hand so what's stopping you? If you want it to be more proud i.e. positive topography then order 0.8 or 1mm.
paulat
22-03-2017, 08:42 PM
Thanks
Sent from my SM-G900F using Tapatalk
Dennis
22-03-2017, 10:37 PM
Better still, give it a go in copper first.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.