PDA

View Full Version : Little Torch



vernon
03-09-2015, 09:40 AM
I am sure I am not the only one to drop my Little Torch! Unfortunately it landed on the end of the nozzle partly flattening it :( What I have done is the following.
Find a small drill which will fit the shank in the flattened tip, if you cannot get any drill in the tip then get a new one.
use pointed tip smooth pliers and carefully squeeze on the tip while rotating it. This should make it round again.

You cannot do this with the smallest sizes as they have Sapphire tips, but then they shouldn't flatten.

I found before doing this the tip wouldn't produce a round flame and it blew out all the time due to the back of the flame not touching the nozzle. After it again produced a round flame which doesn't blow out.