View Full Version : Bezel Setting in a Palladium Band
Hi all, I have taken a commission for a gents wedding band, with a low bezel setting for the customer's own diamond to be set in - the only problem is I've not heard good things about soldering palladium - can anyone shed any light on this for me? Any hints & tips will be much appreciated.
Thanks, Jo
josef1
28-07-2015, 01:26 PM
Its similar to gold but hotter you will need plenty of heat (water torch is ideal) you can use platinum solder but your better off with palladium solder
Thanks for the reply - I've heard that Flux should not be used?
josef1
28-07-2015, 02:18 PM
with palladium solder no flux is needed
http://www.stuller.com/benchjeweler/resources/bencharticles/view/palladium-soldering-techniques/
ps_bond
28-07-2015, 04:46 PM
With a laser no solder is needed :D
orestruck
30-07-2015, 03:46 PM
From what I understand from our bench jewellers at work, it doesn't like overworking or too much reworking.....gets a bit brittle after several sizing a for example, so I'm told.
Sarah
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.