PDA

View Full Version : how to make a silver clay hand print Tube bead for a Pandora bracelet



michelle dolby
08-08-2012, 07:22 PM
i make silver clay hand print jewellery well have been doing a little while not a pro but will get there i wanted to make a tube bead that will go onto a Pandora bracelet or chain i have seen them on a few sites but there is nothing on utube on how to make them, im assuming that u would cut clay out to a rectangle then put prints on and wrap around a tube and join the ends up and allow to dry before taking off the skewer then u can file but don't no only guessing , any ideas :)

Alison Kennedy
25-09-2014, 06:44 AM
Hi did you ever find out how to do this? I would love to know and can't find any info anywhere.
Many thanks