View Full Version : Working with sheet aluminium
Hello,
Does anybody know the dangers of working with sheet aluminium? Ie using a piercing saw to make jewellery. Should I be wearing gloves/mask etc? I have been informed today that it causes cancer if ingested! I have read a bit about it, but thought I would drop you guys a line too. Any advice appreciated, thank you x x
Kwant
11-05-2012, 05:36 PM
You do know you aint supposed to snort the filings don't ya? :0)
this is the outfit I wear when working
http://cfnewsads.thomasnet.com/images/large/023/23609.jpg
Wallace
11-05-2012, 06:05 PM
You do know you aint supposed to snort the filings don't ya? :0)
this is the outfit I wear when working
http://cfnewsads.thomasnet.com/images/large/023/23609.jpg
Very, erm............ fetching??? :giggle:
Tabby66
11-05-2012, 08:30 PM
nice Kwant.....:dance:
sheepy
11-05-2012, 10:41 PM
I didn't realise that workshops could be such 'clean' rooms Kwant to warrant such an outfit! must take the dustpan & brush to mine more often.
Neve, if you find you need to anneal your aluminium if it work hardens, a tip I was given in uni was to smear the metal with wet hand tablet soap. it goes black under the torch but washes off.
Sarah
Erm, thanks? LOL. I will take that as a 'you don't need to worry about a thing' and duff up the person that told me :)
Ps nice all in one, good look ;)
X x x x
Tabby66
12-05-2012, 06:50 PM
Erm, thanks? LOL. I will take that as a 'you don't need to worry about a thing' and duff up the person that told me :)
Ps nice all in one, good look ;)
X x x x
You'll enjoy it here Neve ;D
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.