pedromorgan
08-04-2011, 07:32 PM
Hello folks. I am having some problems with my soldering. About 1 in 5 of my joints seems to go horribly wrong, suddenly the silver seems to blister and the finished part is very ugly and about half the thickness.
I dont think its the materials as there seems to be no pattern to it other than me doing something wrong.
It happens both when i use a paste solder and when i use a strip solder.
I only solder silver.
Any suggestions would be greatly apreciated.
Peter
I dont think its the materials as there seems to be no pattern to it other than me doing something wrong.
It happens both when i use a paste solder and when i use a strip solder.
I only solder silver.
Any suggestions would be greatly apreciated.
Peter